Hongke is a professional manufacturer of lime rotary kiln equipment, with more than 30 years of R & D experience. For this part of lime rotary kiln, we have a professional engineering technology department to complete the R & D and manufacturing of lime rotary kiln, as well as the later installation and commissioning.

Generally speaking, for lime rotary kiln, the working environment is dusty, the material temperature is high, and the lubrication condition is poor. Therefore, special attention should be paid to the maintenance in the specific operation process, so as to extend its service life. The correct use methods of lime rotary kiln are as follows: 1. Add lubricating oil to bearing, reducer and roller before start-up, check whether the fasteners are loose and whether there are obstacles in the running parts. 2. Test the empty car and observe the current. If it is normal, it can be loaded and put into production. 3. During the loading operation of lime rotary kiln, the flexible rotation of traction chain and roller shall be checked to see whether there is deviation; whether the lubricating oil quantity of lubricating points is sufficient; when problems are found, they shall be handled in time. 4. Always pay attention to the current fluctuation of lime rotary kiln motor. If the fluctuation range is large, find out the reason on site. 5. There are many reasons for the self-stop of lime rotary kiln, which may cause electrical failure and material sticking. Before finding out the cause, it is not allowed to start the kiln rashly or repeatedly to prevent accidents. 6. Regularly check the tooth profile of the sprocket wheel of the lime rotary kiln, the wear degree of the roller edge and the upper and lower rails. If the wear is serious, the new parts shall be replaced. Maintenance knowledge of lime rotary kiln: check whether the oil level of reducer is normal. If the roller is seriously worn and the tooth profile of head sprocket is worn thin, it should be replaced in time. When the frame is bent, deformed and sagged, it should be straightened and reinforced in time. After shutdown, the lime rotary kiln shall be inspected comprehensively. If any missing or damaged parts are found, they shall be supplemented or replaced in time. Clean the dust residue inside the body of lime rotary kiln and keep the equipment clean and tidy.

Hongke Machinery Technology Co., Ltd. is committed to the production and development of lime rotary kiln equipment for a long time. It has advanced production technology and professional production skills, and can provide satisfactory lime rotary kiln products for customers. Welcome to Hongke consulting investigation, purchase products.